Main Features:

EPICA Cartridge dual spring Lainer Suspension for WP XPLOR 48.

( SPRINGS ARE Not Included. )

THE EPICA CARTRIDGE HAS BEEN DESIGNED TO PROVIDE THE BEST PERFORMANCE AND COMFORT BY PROVIDING MAXIMUM TUNABILITY

The new EPICA Cartridge System is the culmination of years of experience, testing and development into a single project. The main goal for this project was to develop a highly tunable cartridge to allow riders to fine tune their forks in ways that was never before possible. Below is a break down of the key features of this innovative design.

External adjustments:

• Compression damping – 60 clicks of sensitive adjustment– Adjustment at top of cartridge.
• Rebound damping – 50 clicks of sensitive adjustment– Located at fork bottom.
• External spring preload adjustment – 0 to 15mm– Easily adjusted with a 16mm socket at the fork bottom.

Innovative Features:

• Bladder System
• Our bladder system prevents performance loss that can occur with standard internal spring systems (due to hydraulic support decay).
• Internal oil compensation with increased volume for better high speed response.
• Ability to tune bladder pressures via the side bleed spring.
• EPICA cartridge incorporates Lainer’s Progressive Damping System (PDS) for increased hydraulic damping at the end stroke.
• PDS system has up to 12 different adjustments for the end stroke stiffness.
• High Speed compression piston is reversible with a large range of settings.

Technical Specs:

• Machined from premium 7075 and 6060 alloys and hard anodized.
• Reversible High Speed compression piston – outer diameter = 38 mm.
• Side A (Flat valve surface) – 34mm OD shims for motocross and enduro.
• Side B (Convex valve surface) – 32mm OD shims for supercross.
• Option to configure Low Speed Valve (LSV) on compression base valve.
• Cartridge rod diameter = 14 mm (for an increased oil flow).
• Rebound piston diameter = 25mm for better hydraulic control.
• Compression high/low speed shims ID 12 mm.
• Maximum travel = 310 mm.
• Maximum shim diameter for Mid-Valve By-pass = 21 mm.
• Ability to set Mid-Valve float clearance with the stack shims.
• Mid-Valve/By-pass floating shim ID = 6 mm (for a soft response at high speed on the braking bumps).
• Rebound shims ID = 6 mm (uses triangular mid-valve shims to avoid any oil turbulence on compression).
• Low friction NBR bottom seal.
• Ability to extend the cartridge through the nylon washers.

Fitment: 

• KTM EXC 125   2017-2021
• KTM EXC 150/250/300   2017-2021
• KTM EXC-F 250/350/450/500   2017-2021
• KTM EXC TPI Six Days 250/250F/350F/450F/500F   2017-2021
• HUSQVARNA FE 250/350/450/501  2018-2021
• HUSQVARNA TE 150/250/300  2018-2021