Aprilia RSV4 1000 / 1100 2017 - 2021 7 Button dual mode race switch - bar clamp mount

Download the data sheet Here

This 7 button switch is designed for use on race / track bikes where the road function such as lights, turn signals, and horn are not needed. 

Wiring - No modification needed, this kit plugs directly into the connectors of the standard wiring loom via the CAN BUS interface which is programmed to be 100% compatible with the existing bike electronics, so no diagnostic warning lights.

This assembly replaces both the standard witch assembly and the flipper levers. Also has dual mode operation due to the large number of functions. 

The solution was to use a contemporary layout that is familiar to track riders and split up the host of functions into two modes TRACK / SETUP that are switchable at the touch of a button and indicated by an LED TRACK - In this mode a Blue LED is ON and 6 button functions are allocated to:

• Navigate right
• Navigate left
• Navigate Up
• Navigate Down
• Navigate Push in
• Wifi

RIDER - In this mode the LED is off and these same 6 button functions are allocated to functions needed on track.

• PIT speed limit
• AWC - Up
• AWC - Push
• AWC - Down
• Flipper +
• Flipper -

Type 'C' switches mount directly onto the clutch post using the two original clamp screws and a new dedicated clamp.

For bikes such as the Aprilia which only have a single clutch post bolt the BR - G clamp is provided and mounts directly on to the handlebar.

The clamp is supplied free with each switch, with the default clamp matching the bolt pattern of the standard clutch. However other clamps are available.

• CL - A  32mm inline bolt spacing - Standard
• CL - B  30mm + 7mm offset bolt spacing
• CL - F  30mm inline as found on Accosato / Hel
• BR - G  Generic clamp for any 21.8 > 22.2 mm handlebar ( does not mount on the clutch post )
• CL - J  32mm + 6mm offset bolt spacing - Beringer

BR-G clamp is the default clamp that is supplied when placing an order for this application. Perfect for saving space on the handlebar yet retaining left / right adjustment via slotted bolt holes.

Specification: 

• Billet Aluminum body
• IP 67 waterproof switches with gold plated contacts
• Raychem type 55 wire and DR25 sleeving
• Plug and Play wiring
• Greater crash protection and electrical integrity
• Switch can be replaced separately in the event of a crash
• The switch is a ' Plug In ' component to the LIN module 
• Custom designs are our speciality, so feel free to ask and typically at no extra cost