Honda CBR1000 RR HRC 2020 - Onwards Left and Right Race Switch Set

Kit Includes: 

• Left Side Switch  BD-SW-7BC-40
• Right side brake mount switch BD-SW-6BC-40
• Electronic control module / bike interface

Download the product data sheet Here

There left and right switch assemblies are designed for use on race / track bikes fitted with the HRC kit. All are 100% plug n play with the HRC wiring to provide the following functions, all of which tie in with HRC manual functions. 

Left side switch assembly:

• Pit speed limiter ON
• Pit speed limiter OFF
• Mode A - Up
• Mode A - Down
• Mode B - Up
• Mode B - Down
• Left navigate - Function

Right side switch assembly:

• Right navigate - Function
• Slick / Wet tyre
• Launch
• Stop / Run
• Start
• Rain light

Type C switches mount directly onto the brake pump body using the two original clamp screws and a new dedicated clamp. The clamp is supplied free with each switch, with the default clamp matching the stock master cylinder.  

Available Clamps:

• BR - A   32mm in - line bolt spacing - Standard
• BR - B  30mm offset bolt spacing 
• BR - N  32mm in - line with a left offset for short brake levers typically Brembo RC , RCS
• BR - F 30mm in - line as found on Accosato brake parts
• BR - G Generic clamp for any 21.8 > 22.2mm handlebar ( does not mount to the master cylinder )
• BR - J  32mm of offset bolt spacing - Beringer

Unless otherwise specified the default supplied clamp is the BR - A clamp for this application.

Clamps may be bought separately should you change this part at a future time, there is no need to replace the switch assembly. Perfect for saving space on the handle bar yet retaining left / right adjustment via slotted bolt holes. 

The clutch side switch uses generic 32mm handlebar clamp BR - G

Both the left and right side switches are connected to the bike via our dedicated interface module. This is located under the tank cover near the ECU. Switches and clamps can be purchased  separately for replacement if they have been damaged in a crash.

Specifications:

• Billet aluminum body
• IP 67 waterproof switches with gold plated contacts
• Raychem type 55 wire and DR25 sleeving 
• Plug and play wiring
• Greater crash protection and electrical integrity
• Designed and made in the UK by Bike Sort Developments
• Custom designs are available